Temperature, humidity, weather

Sensirion AG, the expert in environmental sensing, now offers a multi-gas, humidity and temperature module, the SVM30. The module facilitates product development and sensor integration while at the same time offering great flexibility for product...

Texys: “This new upgraded version of our patented THA thermocouple amplifier is now able to sample at 5KHz or 10KHz. The amplification electronics are incorporated into the rear of the thermocouple connector, controlling the compensation of...

Exergen Global: With the low cost of the IRt/c.01 and its direct compatibility with inexpensive, widely available thermocouple input devices, powerful infrared scanning arrays can now be considered for applications in which thermal signatures are...

greenTEG AG: Researchers used greenTEG’s heat flux sensors to thermally characterize a geopolymer concrete containing phase change material (PCM). The PCM containing cube showed improvement in thermal performance compared to the reference....

Exergen Global: Non-contact thermal sensors are remarkably diverse devices that can help ensure higher process speeds, more precise accuracies, tighter tolerances, and higher yields for a wide spectrum of manufacturing processes, including...

greenTEG AG: Researchers used greenTEG’s gSKIN heat flux sensors to study the effects of electrode composition on heat generation in Electrical Double Layer Capacitors (EDLCs). The heat flux sensors were integrated within an isothermal...

InfraTec GmbH: Pyroelectric detectors are ideally suited for gas analysis. Until now, this has been complicated if many gases should be measured. There were often simply too few measuring channels for this purpose. The new LRM-278 from InfraTec...

WIKA:  An individual red-green marking on pressure gauges and dial thermometers is now also possible using an adhesive label. WIKA offers a corresponding set of arcs for nominal sizes 63, 100 and 160. The red and green arcs can be mounted in...

Exergen Global announced the industry’s only non-contact thermal dynamic management solution to combine a proprietary-design cooling mechanism with a unique emissivity control device to provide accurate, repeatable thermal measurement...

E+E Elektronik: The EE850 duct mount sensor from E+E Elektronik combines the CO2, relative humidity (RH) and temperature (T) measurement in a single device. The sensor can be easily integrated into a bus system via the RS485 interface (Modbus RTU...

Balluff is expanding their range of sensors for media-contacting temperature detection, in hydraulic power units for example. New are a temperature sensor with display, a temperature transmitter as well as a PT1000 sensor .The version without...

Optris GmbH: In 2014 and 2016, Optris brought two special infrared cameras for the glass industry – the PI 450 G7 and the PI 640 G7 – to the market. In order to meet the industry-specific requirements, an innovative laminar air purge...

E+E Elektronik: The high-end EE310 and EE360 industrial transmitters from E+E Elektronik are now available with stainless steel or with polycarbonate enclosure. The EE310 humidity and temperature transmitter is dedicated for demanding industrial...

E+E Elektronik: The EE1950 dew point measurement module from E+E Elektronik is dedicated for OEM applications with continuous high humidity and condensing conditions, such as climate and test chambers. Excellent temperature compensation ensures...