back button black v05

ToughSonic® Level & Distance Sensors

ToughSonic® Level & Distance Sensors

09 September 2019
Now available in 1”NPT and 30mm threaded versions

Senix: ToughSonic 3, 12, 14 and 30 ft. versions are now available in either 1.0” NPT or 30mm threaded versins. These flexible and versatile distance and level sensors and SenixVIEW software put the power of ultrasonics in your hands yet retain the simplicity of push-button TEACH setup. You can quickly adjust, optimize, save and clone your applications without calibration!  SenixVIEW allows for over 60 parameter sot be adjusted and optimized for distance and level measurements.

ToughSonic sensors contain a rugged transducer potted in a stainless steel housing for long life.

Outputs respond to measured distance and non-contact technology means nothing touches your material.

Many applications exist in all industries. Contact Senix today to discuss your specific needs.

Features

Distance Measurements

  • Long range, short dead band
  • Unaffected by optical factors like color and transparency
  • PC or button “teachable” setup
  • Narrow beam with adjustments to optimize performance
  • Temperature compensated

Packaging & Performance

  • Quick mounting
  • Durable sealed housing for wet or dirty applications
  • Short & overload protected I/O
  • Multi-sensor synchronization
  • Adjustable sensitivity
  • Rear status indicators (3)

Free Functionality using adjustable interface features like switch hysteresis and time delays to build complete solu- tions such as pump or material flow controllers. Save cost by eliminating PLCs, delay circuits and time delay relays!

PC Setup Power

Use SenixVIEW software (see separate data sheet) to select and adjust all interfaces, timing parameters, filters and modes. Then view, analyze or log data to optimize your application.

Flexible configuration means fewer parts to stock and quick duplication! Higher volume OEM options are available.

Push-button "teach" features provide for several common adjustments when a PC is not available.

Output Selection

In addition to the model's serial data interface there are two SenixVIEW selected outputs to suit your application. All outputs have configurable endpoints, set- points, event responses and time delays.

Voltage & Current Loop are both provided simultaneously in standard (0-10 VDC, 4-20 mA) or custom ranges. They are fully configurable and can either rise or fall with increasing distance.

Switches can be selected in lieu of one or both analogs, and set to either "PNP" or "NPN" type (sourcing or sinking). Each has independently adjustable set point, hysteresis, window, initial conditions, ON delay, OFF delay and loss of target response for ultimate flexibility.

  • Senix
    10516 Route 116
    Suite 300
    Hinesburg, VT 05461
    United States / America
    Tel.: +1 802-489-7300
            +1 800-677-3649  (Toll Free)
    Fax: +1-802 489 7400
    Email: customer.service@senix.com
    Web :
    www.senix.com
  • company website button
  • all entries button

back button black v05