back button black v05

SG for fiber composites available immediately ex stock from HBM

User-Friendly and Space-Saving Measurement Chains for Forces Ranging From 50 N to 50 KN

05 June 2020

The C9C and U9C force sensors from HBM are now also available with a permanently connected inline measuring amplifier. This design makes it much easier to set up the measuring chain, as there is no more soldering or crimping and no need to configure a measuring amplifier. A current-output (4—20 mA) and a voltage-output (0—10 V) version are available, so users can continue working with existing hardware. The measuring chain has been calibrated as a unit.

The new, low-noise electronics is optimally matched to the miniature force sensors. Like the sensors, the amplifier modules meet the requirements of the IP67 degree of protection. This enables the use of the force transducers with inline amplifiers under harsh conditions. The new amplifier modules have also been mechanically tested for shock and vibration and meet the same high requirements as the sensors. Since both the housing of the force transducer and the housing of the electronics are galvanically connected, the entire measuring chain operates in a Faraday cage, so that the measurement results are reliable even under unfavorable conditions. The measuring chain has been EMC-tested in HBM's inhouse laboratory.

The U9C and C9C series sensors are particularly well-suited for fast force measurements, so the new amplifier modules boast 2 kHz rated bandwidth. The amplifiers’ accuracy class (0.15) also matches that of the miniature force transducers (0.2). The measuring chains can be calibrated in the HBM calibration laboratory in compliance with DKDR3-3 or the ISO376 standard to guarantee compliance with the requirements of quality standards and potential audits.

Refer to the provided documentation to find out which output signal in V or mA is the output for the respective measured force. To facilitate parameterization of the next stage, the documentation also contains information on the measurement chain sensitivity and the setting up of two-point scaling.

  • Hottinger Baldwin Messtechnik GmbH
    Im Tiefen See 45
    64293 Darmstadt
    Germany / Europe
    Tel.: +49 (0)6151 803-0
    Fax: +49 (0)6151 803-9100
    Email: info@hbm.com
    Web : www.hbm.com
  • company website button
  • all entries button

back button black v05